Lvc573a datasheet на русском pdf

Inputs Accept Voltages to 5. These devices feature 3-state outputs designed specifically for driving highly capacitive or relatively low-impedance loads. While the latch-enable LE input is high, lvc573a datasheet на русском pdf Q outputs follow the data D inputs. When LE is taken low, the Q outputs are latched at the logic levels at the D inputs. A buffered output-enable OE input can be used to place the eight outputs in either a normal logic state high or low logic levels or the high-impedance state.

lvc573a datasheet на русском pdf

Добавил: Ариадна
Размер: 70.59 Mb
Скачали:17730
Формат:ZIP архив





СКАЧАТЬ LVC573A DATASHEET НА РУССКОМ PDF

When LE is taken low, the Q outputs are latched at the logic. A buffered output-enable OE input. The high-impedance state and increased drive provide. OE does not affect the internal operations of the. Old data can be retained or new data can be entered while.

These devices feature inputs and outputs on opposite sides of the.


Stresses beyond those listed under "absolute maximum ratings" may cause permanent damage to the device.

СКАЧАТЬ LVC573A DATASHEET НА РУССКОМ PDF

The I OFF circuitry disables the. However, STMicroelectronics assumes no responsibility for the. Input clamp current, I. Please be aware that an important notice concerning availability, standard warranty, and use lvc573a datasheet на русском pdf critical applications of Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.

These devices are fully specified for partial-power-down applications using I. Supply voltage range, V. The I OFF circuitry disables the output preventing damaging current backflow when the device is powered down. Storage temperature range, T. Production processing does not necessarily include.



lvc573a datasheet на русском pdf

When LE lvc573a datasheet на русском pdf taken low, the Q outputs are latched at the logic. These devices feature inputs and outputs on opposite sides of the package that facilitate printed circuit board layout. In the high-impedance state, the outputs neither load nor drive the bus lines significantly.

This is a individually operated, non profit site. When the LE is taken low, the Q outputs.






СКАЧАТЬ LVC573A DATASHEET НА РУССКОМ PDF БЕСПЛАТНО

lvc573a datasheet на русском pdf

Input voltage range, V. Input clamp current, I. The remaining output is. When LE is taken low, the Q outputs are latched at the logic.

The value of VCC is provided in the recommended operating conditions table. In the high- impedance state, the outputs neither load nor drive the bus lines significantly.



LVC573A DATASHEET НА РУССКОМ PDF

lvc573a datasheet на русском pdf

The value of VCC is provided in the recommended operating conditions table. Input clamp current, I. The device is designed for operation with a power supply range of 1.



LVC573A DATASHEET НА РУССКОМ PDF СКАЧАТЬ
lvc573a datasheet на русском pdf


The inputs are tolerant to 5. Refer to Test Circuit. Exposure to absolute-maximum-rated conditions for extended periods lvc573a datasheet на русском pdf affect device reliability. Time D to Q. Absolute Maximum Ratings are those values beyond which damage to the device may occur.

A buffered output-enable OE input can be used to place the eight outputs in either a normal logic state high or low logic levels or the high-impedance state.


Lvc573a datasheet на русском pdf